Upgrading and Installing Memory in Computer

Upgrading your computer memory (RAM) is one of the easiest ways to improve speed and performance. Although computer RAM is less a problem today than it was in the past, you might be surprised to discover your computer is running only a fraction of the memory capacity, it can. With RAM being so cheap, maxing out your computer's memory may be the most affordable way of improving performance.

How to buy and install memory

Probably the fastest way to buy RAM is to visit a top online retailer like Crucial or Kingston. They have tools on their site to help you find the type of memory your system requires. In some cases, they will be able to scan your computer and identify the amount of RAM you currently have and give you a list of options on what to buy. The most of your system, you may find that you have to throw the existing modules. For example, if you have two 512 MB modules take two spaces, you want to take those and buy two 1 GB modules

Once you have the RAM, you'll need to open the case and find the memory slots on the motherboard. You will normally see between two and four slots. Sometimes these sites will be numbered and color coded. For example, you could see the numbered boxes on the motherboard as 1-3-2-4, with one and two slots are color and slots three and four being another. This indicates that the RAM should be installed in pairs. So if you have two sticks of 1GB, you want to install them in the 1st and 2rd slots to match them.

You can install one stick of RAM DDR Installed in pairs may improve performance. But always check with the requirements of the motherboard in the selection of memory. Crucial.com has a lot of information on your computer or motherboard and give you an idea of whether your submission should be two or may be installed by themselves.


For technical Installing RAM

Want to put the computer on a solid flat surface such as a table or floor. Open the case. Touch bare metal inside the computer chassis to ground yourself and protecting against electrostatic discharge (ESD). Locate the memory module closest to your CPU. You should find this to be a memory bank. If you install a second stick, to locate two memory banks. Next, open the clips of the current memory. Grab the corners of memory and lift straight up to remove an existing key.

If you install memory in an open slot, release the clips on each side of the bank and match the notches on memory with the keys on the memory slot.

 The memory can be installed only in one direction, so make sure you have these properly aligned to reduce the risk of damaging the motherboard or a RAM module. Press the card firmly down until you hear the clips snap closure.

Do not force the memory if it is wrong. If you experience problems, remove the memory and take a closer look at what you do. The memory should be pressed firmly, but we must go with little resistance.